Programming The Data Channel - Siemens SIMATIC HMI Operating Instructions Manual

Configuring the operating system

6.7 Programming the data channel

Procedure
1. Select the "Enable Vibration Alarm" check box.
2. Confirm your entries.
Result
The vibration alarm is activated.
6.7 Programming the data channel
Introduction
You can only transfer a project if you have enabled at least one data channel.
If you block all data channels, the HMI device is protected against unintentional overwriting
of the project data and HMI device image.
Note
Data channel 1 is not available with the Mobile Panel 277 Wireless.
Requirements
The "Transfer Settings" dialog box has been opened using the "Transfer Settings"
160
The dialog closes.
Mobile Panel 277F IWLAN
Operating Instructions, 12/2007, A5E01003940-01
icon.