Siemens SIMATIC HMI Operating Instructions Manual page 142

Configuring the operating system
6.4 Changing settings for operation
①
②
③
④
Procedure
Proceed as follows:
1. If you want to enable character repetition, select the "Enable character repeat" check box.
2. If you want to change the delay, press a button or the slider in the "Repeat delay" group.
3. If you want to change the repeat rate, press a button or the slider in the "Repeat rate"
group.
4. Verify your settings.
5. Confirm your entries.
Result
The character repetition and delay are set.
142
Check box for selecting the character repeat
Slider control and buttons for the delay time before character repeat
Slider control and buttons for the rate of the character repeat
Test box
Moving the slider to the right will shorten the delay. Moving to the left will extend the
delay.
Moving the slider to the right will shorten the repeat rate. Moving to the left will extend the
repeat rate.
– Touch the test box. The screen keyboard opens.
– Move the screen keyboard as needed.
– Touch any character and keep it pressed.
– Check the implementation of the character repetition and the rate of the character
repetition in the test box.
– Correct your setting if necessary.
The dialog closes.
Mobile Panel 277F IWLAN
Operating Instructions, 12/2007, A5E01003940-01