Sercos Interface (X7), Option; Light Emitting Diodes (Leds); Connection Diagram - Kollmorgen ServoStar 400 Assembly & Installation

Interfaces
4.11.3

SERCOS interface (X7), option

This section describes the SERCOS interface of the SERVOSTAR 400. Information on
the range of functions and the software protocol can be found in the manual "IDN Refer-
ence Guide SERCOS". For the optical fibre (LWL) connection, only use SERCOS compo-
nents to the SERCOS Standard IEC 61491.
4.11.3.1

Light emitting diodes (LEDs)

RT:
TT:
Err:
4.11.3.2

Connection diagram

Layout of the SERCOS bus system in ring topology, with optical fibre cables (schematic).
54
indicates whether SERCOS telegrams are being correctly received. In the final
Communication Phase 4 this LED should flicker, since cyclical telegrams are being
received.
indicates that SERCOS telegrams are being transmitted. In the final Communi-c
ation Phase 4 this LED should flicker, since cyclical telegrams are being trans-
mitted. Check the stations addresses for the controls and the servo amplifier if:
- the LED never lights up in SERCOS Phase 1 or
- the axis cannot be operated, although the RT LED is lighting up cyclically.
indicates that SERCOS communication is faulty or suffering from interference.
If this LED is very bright, then communication is suffering strong interference, or is
non-existent. Check the SERCOS transmission speed for the controls and the
servo amplifier (BAUDRATE) and the fibre-optic connection. If this LED flickers,
this indicates a low level of interference for Sercos communication, or the optical
transmitting power is not correctly adjusted to suit the length of cable.
Check the transmitting power of the (physically) previous SERCOS station.
The transmitting power of the servo amplifier can be adjusted in the setup software
DRIVE.EXE on the SERCOS screen page, by altering the LWL length parameter
for the cable length.
07/05
SERVOSTAR
Kollmorgen
®
400 Installation Manual