Kollmorgen
7
Appendix
7.1
Transport, storage, maintenace, disposal
Transport:
Packaging:
Storage :
Maintenance:
Cleaning :
Disposal :
®
SERVOSTAR
400 Installation Manual
07/05
— only by qualified personnel
— only in the manufacturer's original recyclable packaging
— avoid shocks
— temperature
-25 to +70°C, max. rate of change 20°C/hour
— humidity
max. 95% relative humidity, no condensation
— the servo amplifiers contain electrostatically sensitive components
—
which can be damaged by incorrect handling. Discharge yourself
—
before touching the servo amplifier. Avoid contact with highly
—
insulating materials (artificial fabrics, plastic films etc.).
—
Place the servo amplifier on a conductive surface.
— if the packaging is damaged, check the unit for visible damage.
—
In such a case, inform the shipper and the manufacturer.
— recyclable cardboard with inserts
— dimensions
SERVOSTAR 4xxA (HxWxD) 100x300x270 mm
SERVOSTAR 4xxM (HxWxD) 150x300x270 mm
— labelling
instrument label on outside of box
— only in the manufacturer's original recyclable packaging
— the servo amplifiers contain electrostatically sensitive components
—
which can be damaged by incorrect handling. Discharge yourself
—
before touching the servo amplifier. Avoid contact with highly
—
insulating materials (artificial fabrics, plastic films etc.).
—
Place the servo amplifier on a conductive surface.
— max. stacking height:
— storage temp.
–25 to +55°C, max. rate of change 20°C/hr
— humidity
relative humidity max. 95%, no condensation
— storage duration < 1 year without restriction
> 1 year: capacitors must be re-formed before
the servo amplifier is commissioned.
To do this, remove all electrical connections and
supply the servo amplifier for about 30 min. from
230V AC, single-phase, on terminals L2 / L3.
— the instruments do not require any maintenance
— opening the instruments invalidates the warranty
— if the casing is dirty
do not immerse or spray
— if there is dirt inside the unit
— dirty protective grill (fan)
— you can dismantle the servo amplifier into its principal components
—
by screwing it apart (aluminium heat sink, steel housing sections,
—
electronics boards)
— disposal should be carried out by a certified disposal company.
—
We can give you suitable addresses on request.
8 cartons
: cleaning with Isopropanol or similar
: to be cleaned by the manufacturer
: clean with a dry brush
Appendix
67