Mounting The Device To A Panel - Siemens RUGGEDCOM RSG907R Installation Manual

Chapter 2
Installing the Device
1
2
Figure 4: Removing the Device from a DIN Rail
1. DIN Rail 2. DIN Rail Bracket
2. Swing the bottom of the device up and away from the DIN rail.
3. Lift the device off of the DIN rail.
Section 2.4.2

Mounting the Device to a Panel

For panel installations, the RUGGEDCOM RSG907R can be equipped with panel adapters on the top and bottom of
the chassis. The adapters allow the device to be attached to a panel using screws.
To mount the device to a panel, do the following:
1. Secure the mounting adapters to the top and bottom of the device using the four M4 screws each included
with the device.
10
RUGGEDCOM RSG907R
Installation Guide
Mounting the Device to a Panel