Connecting The Device To The Network - Siemens RUGGEDCOM RSG907R Installation Manual

Chapter 2
Installing the Device
LO Power Supply Configurations
Figure 16: Single Low DC Power Input Configuration
Section 2.7

Connecting the Device to the Network

Steps to connect the device to the network are application-specific.
Connecting to a Local Area Network
In this application, the device operates as a switch on a Local Area Network (LAN). Connect the device as follows:
18
-
+
Figure 17: Dual Low DC Power Input Configuration
RUGGEDCOM RSG907R
Installation Guide
-
+
-
+
Connecting the Device to the Network