Table of Contents
Advertisement
8.8.5
Unit Address Setup Menu
The master station responds to messages directed at the Modbus slave address set using this page.
Note that in some cases when using Pakscan Generic Modbus protocol settings the master station will
respond to more than one address, and the setting here is the Base address. There is more
information on the base address and offset addresses in the Pakscan Modbus Protocol document
(S171E). Valid Modbus addresses are from 1 to 247 inclusive.
Commands available:
1
-
-
MENU
57 of 132
1>Masterstation
=
Set up the Pakscan data Modbus address
Return to previous menu
Publication S177E V2.0 Issue 12/04
Modbus slave address
1
Interface and Menus
Advertisement
Table of Contents
Need help?
Do you have a question about the Pakscan IIE and is the answer not in the manual?
Questions and answers