rotork Pakscan IIE System Manual page 36

Pakscan IIE System Manual
Top Menu – Master Station Status
1. Master Station
1.
2.
3.
4.
5.
9.
36 of 132
Status, Alarms and Tag
Reset Loop (reconfigure the 2-wire loop)
Start Configuration Mode (enable the use of MasterTools)
Change Master (Hot Standby Systems only)
Diagnostics (enter Diagnostic mode)
1. Port 1
2. Port 2
3. Loop
1. Loop Map
2. Loop Test
3. Address fault prompt
4. Inter Unit comms
Setup (enter Setup mode)
1. Ports
1 or 2
2. Standby Setup Actions
1. Copy data to standby
2. Copy address to standby
3. Copy Master Station Tag to standby
3. Loop Shows current loop status and settings
1. Set speed (shows current speed)
2. Set new FCU speed (for global change)
3. Set Number of FCU
4. Set Doubling status
5. More options
4. Address Shows current address settings
Set master station address
5. Tags Sets up all tags
1. Set master station tag
2. Select FCU number (to change tag)
3. Set FCU tag
6. Time Shows current date and time setting
1. Set Date
2. Set Time
7. ESD Shows current ESD option settings
1. Enable/Disable Serial Comms ESD
2. Enable/Disable Keypad ESD
3. Enable/Disable hard wired ESD input
8. Security
1. Set PIN in or out of use
2. Set PIN
3. Set access level
ESD (initiate an ESD)
Publication S177E V2.0 Issue 03/05
Software Version, Port status
Port Activity
Port Activity
Loop status
Select Port 1 or 2
1. Set use (Port 2 only)
2. Set protocol
3. Set speed
4. Set Parity
5. Set Port mode when Standby
Passive or Active
6. Set Alarm Options
Separate or Linked alarms for ports
1. Retain last data on comms fail
2. IQ DV convert (0% to 'Close')
Shows current security level