Function Of The P Buttons; Deactivating The P Buttons; Startup Behavior; Setting The Startup Behavior - Eaton easy500, easy700 Operating Instructions Manual

5 settings

5.7 Startup behavior

5.6.2 Function of the P buttons

5.6.3 Deactivating the P buttons

5.7 Startup behavior

5.7.1 Setting the startup behavior

178
The P buttons are only active in the Status display. In this display you can use
the P buttons to activate inputs in your circuit diagram.
￫
If a text is displayed, the P buttons only function if a value entry
is not carried out.
P BUTTONS å
▶ Select
easy changes the display to
￫
If you delete a circuit diagram in easy, the P buttons are
automatically deactivated. If all circuit diagrams are loaded from
the memory card or easySoft, the set state is transferred.
The startup behavior is an important aid during the commissioning phase.
The circuit diagram which easy contains is not yet fully wired up, or the
system or machine is in a state which easy is not permitted to control. The
outputs should not be controlled when easy is switched on.
￫
The easy models without a display can only be started in RUN
mode.
Requirement: easy must contain a valid circuit diagram.
￫
Default settings:
RUN mode is activated.
Switch to the system menu.
￫
If easy is password-protected, the System menu can only be
accessed after easy has first been "unlocked" (￫ Section
"5.1.4  unlocking", from page 165).
Specify the operating mode which easy must use when the power supply is
switched on.
Operating instructions 05/10 MN05013003Z-EN www.eaton.com
and press OK.
and the P buttons are deactivated.
P BUTTONS