Soft; Program Transfer Between Soft And 500/700 - Eaton easy500, easy700 Operating Instructions Manual

6  Internal
6.8 Soft
6.8 Soft
6.8.1 Program transfer between Soft and 500/700
200
easySoft-Basic and easySoft-Pro are PC programs for creating, testing and
managing easy circuit diagrams.
￫
To transfer data between the PC and easy500/700 devices, only
use the original programming cable supplied as an accessory:
• EASY-PC-CAB or
• EASY-USB-CAB
DANGER

There is a danger of electric shock on easy AC devices if the L
phase conductor and N neutral conductor are reversed.
For your safety:
• Use of this original programming cable ensures that the PC
terminal is electrically isolated from the connection voltage
of the L phase conductor (100 to 240 V AC) if the phase
conductor and neutral conductor are reversed. The original
programming cables are optocoupled.
Figure 100: Plug in programming cable
▶ Connect the programming cable to the serial PC interface.
▶ Fit the easy plug into the opened multi-function interface.
▶ Activate the Status display on the easy.
￫
easy cannot exchange data with the PC while the circuit
diagram display is on screen.
The easySoft-Basic or
easySoft-Pro programming software allows you to transfer circuit diagrams
from the PC to the easy device or vice versa. You can also switch the device
to RUN mode from easySoft in order to test the program in the actual wiring.
Operating instructions 05/10 MN05013003Z-EN www.eaton.com