Eaton easy500, easy700 Operating Instructions Manual page 203

6.7.2.3 Saving a circuit diagram to the card
REPLACE ?
6.7.2.4 Loading a circuit diagram from the card
DEVICE-CARD
CARD-DEVICE
DELETE CARD
6.7.2.5 Deleting a circuit diagram on the card
DELETE ?
▶ Select DEVICE-CARD.
▶ Confirm the prompt with OK to delete the contents of the memory card
and replace it with the easy circuit diagram.
Press ESC to cancel.
▶ Select the CARD → DEVICE menu option.
▶ Press OK to confirm the prompt if you want to delete the easy memory
and replace it with the card content.
Press ESC to go back one menu.
CAUTION
Once you have started the CARD → DEVICE transfer, the
following operation is initiated:
• The RAM of the device is loaded from the card.
• The internal program memory is cleared.
• The data is written from the card to the internal retentive
program memory.
This is carried out in blocks. A complete program is not
transferred to the RAM for space reasons.
If an invalid program or an interruption occurs during the read or
write operation, easy500 or easy700 loses the program in the
internal memory.
▶ Select the DELETE CARD menu option.
▶ Press OK to confirm the prompt and to delete the card content.
Press ESC to cancel.
Operating instructions 05/10 MN05013003Z-EN www.eaton.com
6  Internal
6.7 Memory card
199