Table of Contents
Advertisement
4.12.5 Changing time switch channel
Y4
A
ON
04.01.01
OFF 04.03.31
â
Y4
B
ON
04.10.01
OFF 04.12.31
#
You can change time switch channel in either RUN or STOP mode by
selecting the channel required with the cursor buttons
Example:
+
The display on the left shows the parameter display of a year time switch.
The cursor is flashing on channel
Í
▶ Press the
+
You can use the
Caution - important input rules!
The year time switch only operates correctly if you observe the
following rules:
•
The On year must be before the Off year,
•
ON and OFF times must be specified the same in pairs.
Example of entries in pairs:
•
ON = Day/--/--, OFF = Day/--/--
The ON day should normally have a smaller value than the OFF
day, otherwise the special case applies
(￫ section " Example 8: Selecting a time range of two days
spanning the turn of the year (2-channel)", page 145).
•
ON = --/--/Year, OFF = --/--/Year,
•
ON = --/Month/Year, OFF = --/Month/Year
•
ON = Day/Month/Year, OFF = Day/Month/Year
Operating instructions 05/10 MN05013003Z-EN www.eaton.com
A
.
button to move the cursor to channel
í
button to reach any editable value.
4 Wiring with
4.12 Year Time Switch
ÍÚ
B
.
139
Advertisement
Table of Contents
