Table of Contents
Advertisement
4.7.5 Text Entry
4.7.6 Font
4.7.7 Entering a setpoint in a display
•
STOP operating mode is selected.
•
easy's power supply is no longer present.
•
The OK or DEL + ALT buttons are used to switch to a menu.
The text entry can only be carried out with easySoft-Basic or easySoft-Pro
from Version 6.xx).
The ASCII letters can be displayed in upper and lower case.
•
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
•
a b c d e f g h i j k l m n o p q r s t u v w x y z
•
0 1 2 3 4 5 6 7 8 9
You can edit Cyrillic upper case letters with easy500/700 devices from
version no. 10.
From easySoft version 6.x, the following special characters are permitted in
addition to the blank character and 12 different graphic characters:
° ! # $ % & ' ( ) * + , - . / : ; < = > ? [ \ ] ^ _ ` { | }
Counter with actual value
Analog input scaled as
temperature value
QUANTITY
PCE:0042
!COUNTING!
Figure 58:
Text output examples
Two values from the following sources can be included in a text:
•
actual value and setpoint of function relays,
•
analog input values,
•
Time and
•
Date.
The position of the setpoints and actual values is defined in the middle of the
2nd and 3rd line starting from column 5. The length depends on the value to
be displayed. Setpoint entries in text displays are useful if the PARAMETERS
menu is not available for the display or entry. They are also used if the
operator is to receive a message as to which setpoint he is to change.
Operating instructions 05/10 MN05013003Z-EN www.eaton.com
D1 as error message on
fuse failure
TEMPERATURE
FUSE FAULT
OUT -010 DEG
HOUSE 1
IN
+018 DEG
HEAT..
4 Wiring with
FAILED!
4.7 Text Display
111
Advertisement
Table of Contents
