Restoring Factory Default Settings - Cisco ISA500 Series Administration Manual

Troubleshooting

Restoring Factory Default Settings

Restoring Factory Default Settings
Cisco ISA500 Series Integrated Security Appliance Administrator Guide
To restore the factory default settings, take one of the following actions:
• Launch the Configuration Utility and login. Click Device Management ->
Firmware and Configuration -> Configuration in the left hand navigation
pane. In the Backup/Restore Settings area, click Default.
• Or press and hold the RESET button on the back panel of your security
appliance for about 3 seconds, until the LED lights and then blinks. Release
the button and wait for the security appliance to reboot. If the security
appliance does not restart automatically; manually restart it to make the
default settings effective.
After a restore to factory defaults, the following settings apply:
• LAN IP address: 192.168.1.1
• Username: cisco
• Password: cisco
A
339