Configuring The Time Zone - Cisco ISA500 Series Administration Manual

Device Management

Configuring the Time Zone

STEP 4
STEP 5
STEP 6
Configuring the Time Zone
STEP 1
STEP 2
STEP 3
Cisco ISA500 Series Integrated Security Appliance Administrator Guide
• Secondary RADIUS Server IP: Enter the IP address of the secondary
RADIUS server.
• Secondary RADIUS Server Port: Enter the port number on the secondary
RADIUS server that is used to send the RADIUS traffic. The default is 1812.
• Secondary RADIUS Server Pre-shared Key: Enter the pre-shared key that
is configured on the secondary RADIUS server.
Click OK to save your settings.
Repeat the above steps to edit the settings for other RADIUS groups if needed.
Click Save to apply your settings.
Use the Time Zone / Clock Settings page to manually configure the time zone and
clock settings, or to dynamically synchronize the time zone and clock settings with
the Network Time Protocol (NTP) server.
Click Device Management -> TimeZone / Clock Settings.
The Time Zone and Clock Settings window opens.
Click Manual to manually set the date and time. Enter the values in the Date and
Time fields.
Click Dynamic to automatically synchronize the date and time with the NTP
server:
• Date/Time: Choose the time zone relative to Greenwich Mean Time (GMT).
• Automatically Adjust for Daylight Savings Time: Click On to automatically
adjust the time for Daylight Savings Time, or click Off to disable it.
• Use Default NTP Servers: Click this option to use the default Network Time
Protocol (NTP) server.
10
320