Hardware Installation - Cisco ISA500 Series Administration Manual

Getting Started
Installation
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
Cisco ISA500 Series Integrated Security Appliance Administration Guide

Hardware Installation

Follow these steps to connect the security appliance:
Connect the security appliance to power using the supplied power cord and
adapter. Make sure that the power switch is turned off.
If you are installing the ISA550W and ISA570W, screw each antenna onto a
threaded connector on the back panel. Orient each antenna to point upward.
For a DSL or cable modem, or other WAN connectivity devices, connect an
Ethernet network cable from the device to the WAN port on the back panel. Cisco
strongly recommends using Cat5E or better cable.
For network devices, connect an Ethernet network cable from the network device
to one of the dedicated LAN ports on the back panel.
For a UC 500 or a UC 300, connect an Ethernet network cable from the WAN port
of the UC 500 or a UC 300 to an available LAN port of the security appliance.
For a UC500 or a UC300, connect an Ethernet network cable from the WAN port of
the UC500 or UC300 to an available LAN port on the back panel of the security
appliance.
Power on the connected devices.
Power on the security appliance. The lights on the front panel for all connected
ports light up to show active connections.
A sample configuration is illustrated below.
A NT01
Congratulations! The installation of the security appliance is complete.
Network
Public
Devices
Web Server
10 9 8 7 6 5 4
CONFIGURABLE L A N
Internet
Access
Device
Power
3 2 1 12VDC
A NT02
I
O
WA N RESET POWER
1
22