Registering A Repeater; Master-Slave Mode; Selecting A Slave Handset For Your Phone - Yealink VP59 User Manual

Yealink VP59 & SIP-T58A Phones User Guide
Related Topic
Enabling the Repeater Mode

Registering a Repeater

You need to register a repeater if you want to extend the radio coverage of the phone.
Before You Begin
The repeater mode is enabled, and the phone is in the repeater registration mode.
Procedure
1. Plug the repeater into an AC outlet.
POWER LED glows green and DECT LED flashes red.
2. Enable the repeater registration mode on the phone.
If a phone is found, DECT LED will flash orange.
When DECT LED glows green/orange, the registration to the phone is successful.
Related Topics
Enabling the Repeater Mode
Setting the Phone to the Repeater Registration Mode

Master-Slave Mode

You can use the VP59/SIP-T58A phone as a master handset while binding a slave handset to it.
The phone account is applied to the slave handset, and all line statuses (for example, DND) on the phone and slave
handset are synchronized. You can use the phone while you are sitting at your desk, and use the slave handset while
away from your desk to enhance your business activities.
The master phone and the slave handset can share contacts. For more information, refer to
Master-Slave mode is available only when one handset is registered. For more information, refer to
tration.
Note
After the handset is bound to your phone as a slave handset, the assigned outgoing/incoming line(s) configured for the
handset by your administrator is disabled.
Topics

Selecting a Slave Handset for Your Phone

Push an Active Call to the Slave Handset
Pull an Active Call from the Slave Handset
Selecting a Slave Handset for Your Phone
You can select a slave handset for the phone, and configure a mode for whether to continue the conversation of the
slaver handset when the phone goes off-hook.
There are two slave modes:
Busy: You cannot switch the active call between the phone and slave handset. Regardless of the master handset or
l
the slave handset, the device which is during the call can initiate a new call. If you are not in a call and try to initiate
a call on the phone/handset, the phone/handset screen will prompt "Path Busy".
176
Shared Directory.
Handset Regis-