Exerpeutic 1115 Owner's Manual page 16

6. Front Post and Front Post Cover installation
Use the 6mm Allen Wrench with Phillips Screwdriver provided to remove the four
Washers (40), four Bolts (49), one Bolt (39), and one Big Curve Washer (36) from the tube of
the Front Main Frame (73). Slide the Front Post Cover (54) up on to the Front Post (48) and
keep it there. Connect the Extension Sensor Wire (51) to the Extension Sensor Wire I (50).
Connect the Extension Hand Pulse Sensor Wire II (55) to the Extension Hand Pulse Sensor
Wire III (44)
Insert the Front Post (48) onto the tube of the Front Main Frame (73), making sure not to
pinch or disconnect the wires. Secure the Front Post (48) onto the Front Main Frame (73)
with the four Washers (40), four Bolts (49), one bolt (39), and one Big Curve Washer (36)
that were previously removed. Lightly tighten the four Bolts (49) on the side of the Front Post
(48) and one Bolt (39) on the front of the Front Post (48) by hand. After all five bolts are
tightened by hand, tighten the front Bolt (39) with the 6mm Allen Wrench with Phillips
Screwdriver provided until secure. Then tighten the other four Bolts (49) on the side of the
Front Post (48) with the 6mm Allen Wrench with Phillips Screwdriver. Slide the Front Post
Cover (54) down to the Front Main Frame (73).
ASSEMBLY
Tool:
6mm Allen Wrench with
Phillips Screwdriver
14
1PC