Danfoss H1B 060 Service Manual page 45

Service Manual
H1 Bent Axis Motors, Size 060/080/110/160/210/250 cm3
Minor repair
© Danfoss | August 2018
1. Lubricate and install spring (F0040) and spring seat (F0030) into servo.
2. Install a new gasket (C0130).
3. Position control on motor.
4. Install four cap screws (C0110 and/or C0120).
C0110 and C0120 Wrench Size
Screw Control
Electric / Hydraulic proportional
C0110
Two-position
C0110, C0120
Torque Internal Hex
Wrench
37 N•m 6 mm
[27 lbf•ft]
115 N•m 10 mm
[85 lbf•ft]
AX00000025en-US0504 | 45