Ricoh Pro C7200S Operator's Manual page 428

11. Troubleshooting
Message
"Please wait."
"Shutting down... Please
wait. Main power will be
turned off automatically.
Maximum waiting time: 18
minute(s)"
"The power cord(s) has been
disconnected or the breaker
switch is turned off. Turn the
main power off, plug in the
cord(s) to the wall outlet,
and then turn the breaker
switch on."
426
Cause
The current environmental
condition is outside the
recommended temperature
range for the machine.
The shut down procedure
has begun because the
power was turned off while
the machine was in standby
mode or performing an
operation.
• One of the two power
cords is not plugged
into the wall outlet.
• The earth leakage
breaker is in the Off
position.
Solution
• Check the optimum environmental
conditions for the machine and
move it to a different location.
• Leave the machine for a while
and allow it to adapt to the
environment.
For details about the optimum
environmental conditions for the
machine, see page 529 "Optimum
Environmental Conditions After Moving
the Machine".
• Follow the message that appears
and wait until the machine has
shut down. Do not turn on the
power while this message is
displayed. If the power has been
turned on, follow the message
that appears. For details about
turning on and off the power, see
page 91 "Turning On/Off the
Power".
• The shutdown time varies
according to the options that are
installed and the environmental
conditions of the location where
the machine is set up. If the main
power indicator remains lit after
18 minutes have elapsed, contact
your service representative.
• Securely plug the two power
cords directly into the wall outlet.
For details about the power
connection, see page 529
"Where to Put Your Machine".
• For details about handling the
earth leakage breaker, see
page 542 "Checking the Earth
Leakage Breakers".