Using The Booklet Finisher - Ricoh Pro C7200S Operator's Manual

3. Useful Functions
• If you cannot make fold function settings even with a multi-folding unit installed, options may not be
set correctly in the printer driver. To correct the printer driver's option settings, see "Configuring
Option Settings for the Printer", Printer Driver Installation Guide.
• When stapling Z-folded paper, fewer sheets than normal can be stapled together. This is because
a single Z-folded sheet is equivalent to 10 non-Z-folded sheets. For the number of sheets that can
be stapled, see "Specifications for Finisher SR5050" or "Specifications for Booklet Finisher
SR5060", Specifications.
• Depending on the temperate and humidity conditions of the machine's environment and the type of
paper being folded, use of the fold function can cause toner smearing, which can occasionally
result in spoilt prints.
• Wrinkling can occur when applying letter fold-out to B4 JIS , A3 , 8
, or larger sheets. In some cases, you may have to use A4
folds in combination with the reduction function.
• Print quality over fold lines might be reduced. This is due to cracking within the fused toner. Loss of
surface along fold lines can also occur with some types of paper. To avoid possible wastage, print
a single test sheet before beginning a print run.
• Printing will stop if the number of printed sheets exceeds tray capacity. If this happens, remove
printed sheets from the folding unit tray to resume printing.

Using the Booklet Finisher

When the optional Booklet Finisher is attached to the machine, you can fold printed documents in half.
Half Fold
Half Fold positions
Select the position for folding printed documents in half in the printer driver.
When [Half Fold: Print Inside (Finisher Booklet Tray)] is specified, each piece of printed paper is folded
in half with the printed side facing inside, and it is output to the finisher booklet tray.
36
sheets or smaller when applying
CNP014
1
/ 14 , 11 × 17 , 8K
2