General User Input/Output; Jumpers - Altera SDI HSMC Reference Manual

2–18
Figure 2–10. AES3 TX Channel Block Diagram

General User Input/Output

This section describes the user I/O interface to the board.

Jumpers

The board jumper switches are CD_MUTE channels 1 and 2 and EQ_BYPASS channels 1
and 2. In the factory default board configuration, jumpers are installed on the
CD_MUTE jumper switches (J4 and J6) and not installed on the EQ_BYPASS jumper
switches (J5 and J7). When jumpers are not installed on J5 and J7, the EQ_BYPASS
signal can be controlled from the host device.
Table 2–11
SDI HSMC Reference Manual
AES3 TX
lists the jumper descriptions and schematic signal names.
RS422
Driver
RC
Network
Isolation
Transformer
Resistor
Termination
© July 2009 Altera Corporation
Chapter 2: Board Components
General User Input/Output