Kalor Paola 13-13D User Manual page 28

Check every 2-3 days
Cleaning the ash collection compartment
Clean and empty the ash tray being careful with
hot ash. The ash must be completely cold for a
vacuum cleaner to be used to remove it. Only if
the ash is completely cold, you can also use a
canister vacuum cleaner suitable for picking up
particles of a certain size.
Cleaning ash and combustion chamber including
the spark plug lead.
Flame-shell cleaning
Cleaning of stainless steel and satin- nish
surfaces
Normally these surfaces do not need to be
treated, but if they do, avoid cleaning them with
abrasive materials. For surfaces in stainless and
satin brushed steel we recommend cleaning with
a paper towel or a clean dry cloth moistened
with a detergent based on non-ionic surfactants
(<5%) A spray glass cleaner may be used.
Avoid contact with skin cleanser
and eyes. In case this happens,
sprinkle with plenty of water
and contact the nearest medial center.
98
Cleaning of painted pats
Do not clean the painted parts with wet rags when
the unit is in operation or hot to prevent thermal
shock to the paint which may cause it to detach.
Do not use abrasive or aggressive products
or materials. Clean with damp cotton or paper
towels. The silicon paints used by manufacturer
possess technical characteristics that make
them resistent to very high temperatures. There
is however a physical limit (380° C - 400° C)
beyond which the paint begins to fade or (over
450°) to vitrify; it may then ake and detach from
the steel surface. If this happens, it means that
temperatures have been reached that are far
above those at which the unit should operate
properly.
Do not use abrasive materials or
harsh. Clean with damp cotton or
paper towels.
Lower ash drawer cleaning
It is recommended to clean the ash pan from
residues that have fallen during operation.
Remove the grid, take out the tray, empty and
clean the edges with a suction device.