Kalor Paola 13-13D User Manual page 25

Failure on electrical devices
Ignition failure
If the ame does not light up during the switching on or if the smokes temperature does not reach
a suitable value in the foreseen time gap, the Insert switches off and you will read the words
".
L I G H TI N
on the display. Press the key "On/Off" to reset the alarm. Wait until the cooling phase is completed,
clean the brazier and start a new light-up.
Switching off while working
The Insert suddenly switches off while working (for example because it has run out of pellets in the
tank or because the motor reducer for pellets loading got broken). The Insert continues working
until the pellets left in the brazier ends. You will then read the words
and the stove switches off. Press the key "On/Off" to reset the alarm. Wait until the cooling phase
is completed. Clean the brazier and start a new light-up.
These alarms remind you that the brazier must be cleaned and installed correctly before
switching on the Insert.
There is no power supply
In the event of a power drop longer than one minute, the Insert can exhaust some smoke in the
room: this causes no risks. As soon as you have the power supply again, the Insert will have the
words "BLA CK O U T" on the display.
Do not attempt to start the Insert before the required time or it may get blocked.
If this occurs, switch off the switch on the back of the pellet Insert stove for 1
minute, set it on again and wait 10 minutes before starting the Insert again.
The power socket where the Insert is connected should be tted with "earth
connection complying with regulations in force." The Manufacturer shall not
be held responsible for damage to things or people resulting from negligent
installation.
Manual restart thermostat
Intervention in case of danger
In case of re, disconnect the power supply,
use a re extinguisher in accordance with,
and if necessary, call the re department and
then contact an authorised quali ed technical
assistance
"n o p el le t"on the display
RESTART
PELLET
"N O
95