Remote Control - Kalor Paola 13-13D User Manual

It is mandatory to have an opening in the
brick / plasterboard coating to guarantee an
adequate supply of air to the chimney.
It is recommended to replicate the same
opening made on
Alternatively, the suction pipe (Ø 50 mm) can
be connected to the outside of the home. If
the suction tube is taken only outside of the
brick cladding, it is mandatory to have an air
intake on the perimeter wall of the house.
Pellet
The pellets are cylinders of compressed wood, produced from sawdust and wood
processing (chips and sawdust), generally produced by sawmills and carpenters.
The binding capacity of the lignin contained in wood, allows to obtain a
compact product without adding additives and foreign chemicals to
the wood, is therefore obtained a natural fuel with high yield.
The use of expired pellets or any other unsuitable material can
damage parts of the Insert and impair proper operation: this
can lead to the termination of the guarantee, and its producer
responsibility.
For our products use pellets diameter 6 mm, length 30 mm and a maximum of 6% and A1
certi ed according to the UNI EN ISO 17225-2 standard. Keep the pellets away from heat
sources and not in humid environments or with explosive atmosphere.

Remote Control

The remote control (Fig. 3) used to adjust water
temperature power and the on/off functions for
the pellet Insert.
To start the Insert, press key
automatically enter the starting phase.
Press keys + (1) and - (2) to adjust temperature,
and use keys + (6) and - (5) to adjust operating
power.
To turn off the Insert, hold down key .
To replace the 3 volt battery located on the back
of the remote control, pull the centre of the cover
and the lever on the side of the same, replace
the battery observing the correct polarity (Fig. 4)
84
the perimeter wall.
and the Insert will
Remember that it is forbidden to
inhale the combustion air from
bedrooms, bathrooms, garages or
deposits that could have explosive
atmospheres.
Fig. 3 Fig. 3 Fig. 4