SMC Networks BARRICADE SMC7901WBRA2 B1 User Manual page 93

Local IP Address — Specifies the IP address on the local network to
◆
allow external access to.
Local Port — Specifies the port range through which traffic is
◆
forwarded.
Remote IP Address — Specifies the source IP address on the WAN to
◆
allow access from. Leaving this parameter blank allows access from all
traffic.
Public Port — Specifies the external port range on the WAN to allow
◆
access from.
Interface — Selects the WAN interface on which the port forwarding
◆
rule is to be applied.
Add — Adds the configured port forwarding parameters to the Current
◆
Port Forwarding Table.
C P F
URRENT ORT ORWARDING
The Current Port Forwarding Table displays the entries that are allowed to
forward packets through the ADSL Router's firewall.
Select — Selects an entry in the Current Port Forwarding Table.
◆
Local IP Address — Displays an IP address on the local network to
◆
allow external access to.
Protocol — Displays the protocol used for forwarding of this port.
◆
Local Port — Displays the local port range.
◆
Comment — Displays a useful comment to identify the nature of the
◆
port to be forwarded.
◆ Enable — Displays if the configured port forwarding setup has been
enabled.
Remote Host — Displays the source IP address on the WAN to allow
◆
access from.
Public Port — Displays the external port range on the WAN to allow
◆
access from.
Interface — Displays the WAN interface on which the port forwarding
◆
rule is applied.
Delete Selected — Deletes a selected entry from the Current Port
◆
Forwarding Table.
Delete All — Deletes all entries in the table.
◆
– 93 –
| Firewall Configuration
C 8
HAPTER
T
ABLE
Port Forwarding