Table of Contents
Advertisement
S
BSSID
ECOND
the farther the transmission range. Power selection is not just a trade
off between coverage area and maximum supported clients. You also
have to ensure that high-power signals do not interfere with the
operation of other radio devices in the service area. (Default: 60mW;
Range: 60mW, 30mW, 15 mW)
This page configures a second VAP (virtual access point) on the ADSL
Router. Each VAP functions as a separate access point, and can be
configured with its own Service Set Identification (SSID) and security
settings. However, most radio signal parameters apply to both VAP
interfaces.
The VAPs function similar to a VLAN, with each VAP mapped to its own
VLAN ID. Traffic to specific VAPs can be segregated based on user groups
or application traffic. Each VAP can have up to 64 wireless clients, whereby
the clients associate with these VAPs the same as they would with a
physical access point.
Figure 38: Second BSSID
The following items are displayed on this page:
Enable — Enables a second VAP on the wireless interface.
◆
(Default: Disabled)
SSID — Configures the service set identifier of a second VAP (VAP0) on
◆
the wireless interface. (Default: SMCAP-1)
– 77 –
| WLAN Configuration
C
7
HAPTER
Second BSSID
Advertisement
Table of Contents
