Table of Contents
Advertisement
Preparing the System
Connecting the System to a Network
The DisplayPort output includes the entire display. The aspect ratio of the screen is 16:9. To
display this properly, select the 16:10 or 16:9 mode on the monitor or projector, if available.
Also, you may be able to adjust the horizontal and vertical image size controls to create the
correct aspect ratio. You can best judge the aspect ratio by displaying the circle test pattern on
the system.
The setups provide these outputs:
Full Screen, 1920x1080 (1080p): The full display, which is output at 60 frames per second on
the DisplayPort connector. When this option is selected, you cannot use the S-video output.
Image Area Only,1024x768: Outputs the region of interest of the image area to the S-Video
connector in NTSC or PAL format (depending on the system setting).
Connecting the System to a Network
For information on changing the network configuration for the system, see "System
Administration" in the Help. To display the Help, touch
. To close the Help, touch
again or
touch Close.
1. Turn off system power.
2. Connect one end of the provided network connection cable to the wall receptacle for your
network.
3. Connect the other end of the cable to the network receptacle on the system.
4. Turn on the system.
Moving the System
Observe the following warnings and cautions before moving the system.
WARNING
Be aware of the wheels, especially when moving the system. The system could cause injury to
you or others if it rolls over feet or into shins. Use caution when going up or down ramps.
106
EPIQ 7 User Manual 4535 617 25341
Advertisement
Table of Contents
