Omron FH-1 series User Manual page 473

Loading Security Settings
Use the following procedure to load a saved user account and user group settings into the Sensor Con-
troller.
Important
Note that some setting cannot be keep when you load the security setting saved as the older
version than the current software version.
Refer to Loading security settings from an older software version on page 10-37.
1
If the settings were stored in external storage, insert the external storage device containing the
security settings to load into the Sensor Controller.
2
In the Main Window, select [Security settings] from the [Tool] menu.
The [Security settings] dialog box is displayed.
3
Click the [Setting data] tab in the Item Tab Area.
4
Select the file to load from the [Load from file] area.
5
Click the [Load] button.
 Loading security settings from an older software version
When loading security settings from a previous Sensor Controller software version, the settings that
can be transferred will differ depending on the that previous software version. Refer to the following
table. Confirm each setting item and reset as needed.
(1) Loading the security settings in software version 4.12, or earlier.
Password
Switch to ADJUST mode
Non-stop adjustment mode
RUN Control area
RUN Tool box
Additional Information
For the password setting set in FZ4 Ver4.12, or earlier, refer to Transferring Old Security
Settings on page 10-38.
Vision System FH/FHV/FZ5 Series User's Manual (Z365)
Setting item
10 Advanced Usage
Keep Discard
OK
OK
OK
OK
OK
10 - 37
10