Assembling Pivoting Rear Axle - Husqvarna Rider 100 series Workshop Manual

Repair instructions
Assembling the pivoting rear axle
2
1
1 Slide the washer (2) on the pendulum shaft with
the beveled edge against the fork (1) of the
pendulum shaft.
2 Grease the shaft and assemble it in the front
frame.
3 Slide the ring (3) on from behind and fasten the
screw.
4 Roll the rear carriage forward and fit it into the
fork of the pendulum shaft.
38 – English
3
5 Fit the articulated shaft with the short key grip
6 Fasten the cables in their respective positions
7 Fit the wheels.
8 Assemble according to "Replacing the
and plastic cover face down. Ensure the double
D shaft is inserted into the double D hole on the
fork.
between the front and the rear carriage.
Articulated Steering Bearings", reverse order.
Make sure that the cables and controls are
properly adjusted (see Checking and Adjusting
the respective cables).