Checking And Adjusting Accelerator; Replacing Articulated Steering Bearings - Husqvarna Rider 100 series Workshop Manual

Repair instructions
3 Adjust the clutch cable as follows:
• Pull out the rubber sleeve (1). Loosen the nut (2)
and adjust the wire using the adjuster screw (3).
• Tighten the lock nut (2) after adjustment.
Checking and adjusting the accelerator
Rider 111 B/ 112 C/115 C/120 C
1 Remove the cover on the right side of the rear
carriage.
3
4
1
2 Loosen the lock nut (1) on the ball joint.
3 Remove the locking spring (2) so that the ball
socket (3) can be removed from the ball on the
lever arm (4).
4 Press the forward accelerator pedal down
completely and move the lever arm (4) forwards
as far as possible.
5 Adjust the socket (3) position on the connecting
rod (5) so that it fits exactly over the ball on the
32 – English
5
2
lever arm. Fit the socket on the ball.
6 Lock the adjustment with the lock nut (1) and put
the locking spring (2) in place.
Changing articulated steering bearing
Rider 111 B5
Rider 112/ /112 C5/ 115 C/ 120 C
1 Remove the engine cover by loosening two
snap-in locks at the front and two hinges at
the back edge of the engine cover (Only 111B,
111B5).
2 Remove the side cover on the left hand side of
the front carriage. One screw at the side and
one at the top, under the seat.