Husqvarna Rider 100 series Workshop Manual page 41

4 Tighten the hydrostatic transmission cable
clamp.
5 Place the hydrostatic cable at the lowest position
in the fork below the pendulum shaft.
6 Attach the link joint to the lower part of the
hydrostatic transmission cable.
1
7 Place the hydrostatic transmission cable in place
and screw the casing on with the rear bracket
(3).
8 Adjust the hydrostatic transmission cable
as shown, see Checking and Adjusting the
Accelerator.
Connect the rear link joint and fit the locking
spring (2).
Tighten the rear link joint locking nut 1).
9 Secure the hydrostatic cable with plastic ties in
the frame behind the left front wheel.
10 Fasten the frame cover and the front cover.
Repair instructions
3
2
English – 41