Checking And Adjusting Gear Control; Checking And Adjusting Clutch - Husqvarna Rider 100 series Workshop Manual

Checking and adjusting the gear control
Rider 111 B5/112 C5
Check the gear control adjustment by putting the
gear lever in the "N" position. If the machine moves
easily, the lever is properly adjusted.
Otherwise the controls should be adjusted as
follows:
1 The cutting unit should be lowered. Remove the
cover on the right hand side of the front carriage.
2
2 Loosen the lock nut (1) on the ball joint.
3 Remove the locking spring (2) so that the ball
socket (3) can be removed from the ball on the
lever (4).
4 Adjust the socket (3) position on the draw bar (5)
until the socket can easily be placed on the ball.
5 Lock the adjustment with the locking nut (1) and
refit the locking spring (2).
4
3
1
5
Checking and adjusting the clutch
Rider 111 B5
Rider 112/ /112 C5/ 115 C/ 120 C
1 The clutch is properly adjusted when the idler's
outward motion is stopped by the belt and not by
the cable.
2 There should be about 8–10 mm/5/16"-3/8" of
play (A) between the cable nipple and the lever.
Repair instructions
English – 31