Fuel Tank - Husqvarna Rider 100 series Workshop Manual

Fuel tank

Removal
WARNING!
Gasoline is highly flammable and
environmentally hazardous.
Take great care to prevent fires
and avoid spills.
1 Place a suitable vessel underneath the fuel filter
to collect the gasoline in.
2 Empty the fuel tank by removing the hose and
the hose clamp from the lower connection of
the fuel filter. There are two fuel hoses on Rider
120C and 120S.
If draining the tank is not desired, the hose can
be compressed with a locking welding pliers.
Make sure to keep the end of the hose above
the level in the tank from now on.
Rider 111/111B5
B
A
Rider 112/112C5, 115C/120C
3 Remove the two screws (1) holding the tank.
Lower the tank and pull out the hose through the
machine frame.
Assembly
1 It is easier to work if you empty the tank before
assembly. Install the tank and secure it with the
screws (1).
2 Put the hose in place and connect it to the fuel
filter with a hose clip. Make sure the hose does
not chafe.
3 Loosen the tank cap (2) and fill the tank with
gasoline. Check for leakage.
x2
English – 25