Repair instructions
6 Lift the link joint off and remove the hydrostatic
cable. Loosen the rear link joint from the cable.
Turn the cable so that it comes loose from the
front link joint.
1
3
7 Remove the whole hydrostatic cable. Make a
note of how the cable is laid out, so that the new
cable can be correctly positioned.
40 – English
2
4
Fitting the hydrostatic cable
1
3
1 Feed the new cable through the Rider so it runs
the same route as the old one.
\
2 Screw the new hydrostatic cable in as far as
possible on the front link joint and tension the
locking nut.
3 Press the cable sheath into the front attachment
in the center console.
2
4