Dismantling The Cutting Unit Joint And Cabling - Husqvarna 536LiHE3 Workshop Manual

Repair Instructions
9.8 Dismantling the cutting unit joint
and cabling
1
Dismantle the cutting unit and gear package
according to 9.2 Dismantling the gear package on
page 26
2
Refers to side without cabling.
Pry off the lockwasher holding the cabling in place
in the lower cover.
Loosen the cables.
3
Dismantle the adjusting screw used to adjust the
inertia of the angle joint.
Dismantle the lower cover.
4
Loosen the joint for the transport mode sensor (1).
1
2
Loosen the clamp (2).
3
Loosen the bushing (3).
4
Loosen the indexing ring (4)
English – 32