Repair Instructions
9.16 Assembling the control cable - all
models
We recommend dismantling the control unit before
assembling the control cabling, see "8.19 Disman-
tling the control unit" on page 46.
For products with S/N: -20180400173 (LiHE3).
1
Connect the connector to the control unit.
•
Make sure that it snaps into place.
•
Press the silicone gasket in place with your
fingers and make sure it fits tightly all around.
•
Snap on the bracket holder.
NOTE! Do not use the bracket holder to
press the silicone gasket in place.
2
Place the bottom section of the cabling and the fan
in the battery housing.
Assemble the fan, making sure it is positioned in
the correct direction.
3
Assemble the keypad. Make sure the surface is
clean.
Connect the cable (A) to the position marked "B+"
on the main switch (C). Place the parts in the
operating handle. NB! Make sure to apply grease
to the contact surfaces and also the connector,
see service data.
4
Lay the cabling in place in the control handle.
5
Assemble the throttle trigger lock and throttle trig-
ger as described in 8.2 Assembling the throttle
trigger lock and throttle trigger".
6
Lay the cabling in place in the cable tray and as-
semble the control handle and battery housing as
described in "6 Basic dismantle/assembly".
42 – English
C
B
A