Dismantling The Main Switch - Husqvarna 536LiHE3 Workshop Manual

Repair Instructions
9.10 Dismantling the shaft and motor
cabling
1
Dismantle the trigger guard, handle, battery hous-
ing as described in 9.1 General repair instructions
on page 26.
2
Dismantle the clamp holding the shaft.
Unplug the connector for the control unit and to the
transport sensor.
The shaft will now come loose from the battery
housing.
3
Dismantle 9.2 Dismantling the gear package on
page 26.
Assemble 9.3 Assembling the gear package on
page 28.
Assemble in reverse order.

9.11 Dismantling the main switch

For products with S/N: –20180400173 (LiHE3).
1
Dismantle the control handle as described in
7 Basic dismantle/assembly on page 20.
A
2
Dismantle the throttle trigger lock and throttle trig-
ger as described in 8.1 Dismantling the throttle
trigger lock and throttle trigger on page 24.
3
Lift out the main switch and disconnect cable (A).
D
4
Take loose the contact (C) using a small screw-
driver to carefully free the catches (D) on each end
D
of the contact and main switch from each other.
NB! Do not pull the wires. Take special care to
C
avoid damaging the contact (D).
37 – English