Cutting Unit; Clutch, Clutch Drum And Gearbox - Husqvarna 322HD60 Workshop Manual

Hide thumbs Also See for 322HD60:
Table of Contents

Advertisement

7.10.4 To remove and install the stop switch
1. Use a flat screwdriver to loosen the stop switch.
2. Disconnect the 2 cables.
3. Remove the stop switch.
4. Install in the opposite sequence.

7.11 Cutting unit

7.11.1 To remove and install the cutting unit
To remove and
1. Remove the front handle. Refer to
install the front handle on page 27 .
To remove and
2. Remove the throttle handle. Refer to
install the throttle handle on page 27 .
30 - Repair instructions
3. Remove the 3 screws (A).
B
A
C
4. Remove the 2 screws (B).
5. Remove the cutting unit (C).
WARNING: Use protective gloves.
6. Clean the cutting unit.
7. Examine the cutting unit for damage and wear.
Replace damaged parts.
8. Examine the sharpness of the blades. Sharpen the
blades if it is necessary.
9. Install in the opposite sequence.

7.12 Clutch, clutch drum and gearbox

7.12.1 To disassemble and assemble the clutch
To remove and
1. Remove the throttle handle. Refer to
install the throttle handle on page 27 .
To remove and
2. Remove the front handle. Refer to
install the front handle on page 27 .
To remove and
3. Remove the cutting unit. Refer to
install the cutting unit on page 30 .
4. Remove the spark plug.
5. Put the piston stop in the spark plug hole. Refer to
Servicing tools on page 10 .
6. Put the product with the starter unit down.

Advertisement

Table of Contents
loading

Table of Contents