Advertisement
Fig. 11 - Properly Configured Device
You can now click on the Connect tab where the reader should also appear; click on it to select it
and click the Connect button in the lower right corner of the window. The software will then connect
to the reader. You should see a message box appear (Fig. 12) showing the connection status for
the reader and when it has finished connecting to the reader it will disappear and the software will be
ready to use to configure the reader.
Fig. 12 - Connection Status
Conclusion:
You have learned how to reset a reader to factory defaults, learned about control codes, learned
how to take a brand new reader and assign it an IP Address and connect to it.
6
Advertisement
