Advertisement
Tuning the Reader
Introduction:
The Tune function in the software and the Tune button on the reader allow for "optimally" setting a
variety of parameters to obtain an image in which the code can be reliably read without needing to
know much about the settings being made.
Start:
You have just connected to a reader that was reset to factory defaults. The software should have
the Settings tab in the ribbon selected with the Quick Setup view selected by default and it should
look something like the image below (Fig. 13). If it does not look like this you can turn on the various
panes from the View menu and dock them to the desired places in the traditional Windows manner.
Ask for assistance in changing the view if needed.
Fig. 13 - Default Software View
8
Advertisement
