Advertisement
Fig. 9 - Current Device Settings
Select the Use Static IP Address radio button and enter an IP Address and Subnet Mask consistent
with your computers IP Address configuration (Fig. 10). You could create a username and
password if you desire; the default is as shown here. Click Apply.
Fig. 10 - New Device Settings
When you click Apply the command will be sent to the reader and after several seconds the reader
will disappear from the list. At this point the reader is restarting so that the new IP address can be
retained. After a couple of minutes it will finish the reboot and reappear with the new IP address set
(Fig. 11 on next page).
5
Advertisement
