Powering On The Utm Device; Verifying The Utm Device Boot Information - H3C SecPath U200 Series Installation Manual

7. Select VT100 or Auto detect for Emulation and click OK.

Powering on the UTM device

Before powering on the UTM device, confirm the following:
You know where the emergency power-off switch for the equipment room is located.
•
The power cables and grounding cables have been correctly connected.
•
• The input power voltage meets the requirement of the UTM device.
The terminal is properly connected to the UTM device and operating normally, and the
•
communication parameters have been configured as required.
The CF card used to store the applications, if any, is tightly fixed in the UTM device.
•
The interface modules, if any, are properly installed, and the interface cables are correctly
•
connected.
To power on the U200-S device, turn on the power source.
To power on the U200-A or U200-M device, turn on the power source and then turn on the power
switch of the device.
After powering on the device, verify the following items:
1. The LEDs on the front panel show that the device is operating properly. For more information
about the LED behaviors, see
2. The cooling system is working, and you can hear fan rotating noise and feel air being blown out.
3. The boot information on the terminal shows that the UTM device is starting up normally. For more
information, see
4. After the device starts up, a prompt for pressing Enter appears.

Verifying the UTM device boot information

After the UTM device is powered on, the following information appears on the terminal:
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU
Booting Normal Extend BootWare..
The Extend BootWare is self-decompressing....................
Done!
****************************************************************************
*
*
*
****************************************************************************
Copyright (c) 2004-2013 Hangzhou H3C Technologies Co., Ltd.
Compiled Date
CPU Type
CPU L1 Cache
CPU Clock Speed
Memory Type
"UTM device panel
"Verifying the UTM device boot
H3C SecPath U200-S BootWare, Version 1.36
: Apr 9 2013
: XLS404
: 32KB
: 800MHz
: DDR2 SDRAM
LEDs."
information."
29
*
*
*