Performing Basic Configurations; Performing Basic Configurations At The Cli - H3C SecPath U200 Series Installation Manual

Performing basic configurations

To enable the UTM device to communicate with other devices on the network, you must perform some
basic configurations on the UTM device. To do so, first log in to the CLI or Web interface of the UTM
device.
To use an interface as a service interface, you must add it to a non-management security zone in the
Web interface before configuring relevant service functions. For more information, see the UTM device
configuration guides.
This section describes the steps for performing basic configurations on the UTM device. For how to
configure protocols and features on the UTM device, see the UTM device configuration guides.
The syntax of commands and the Web interface vary with software versions.

Performing basic configurations at the CLI

Step
1. Enter system view.
2. Set the device name.
3. Enable the Telnet server.
4. Configure a one-to-one static
NAT mapping.
5. Enter Ethernet interface view.
6. Assign an IP address to the
interface.
7. Enable static NAT on the
interface.
8. Add the interface to a security
zone.
9. Return to the upper-level view.
10. Save the running configuration
to the root directory of the
storage medium and specify
the file as the configuration file
for the next startup.
11. Display the running
configuration.
Command
system-view
sysname sysname
telnet server enable
nat static local-ip [ vpn-instance
local-name ] global-ip
interface interface-type
interface-number
ip address ip-address
{ mask-length | mask } [ sub ]
nat outbound static [ track vrrp
virtual-router-id ]
See the UTM device
configuration guides.
quit
save [ safely ]
display current-configuration
32
Remarks
N/A
Optional.
H3C by default.
Optional.
Disabled by default.
Optional.
By default, no static NAT mapping
is configured.
N/A
Optional.
By default, only GigabitEthernet
0/0 has an IP address
(192.168.0.1).
N/A
This task is not supported at the
CLI. Complete this task in the Web
interface.
N/A
N/A
Optional.