Danfoss VLT HVAC Basic Drive FC 101 Quick Manual page 46

Quick Guide
1 1
Cable lengths and cross-sections
Max. motor cable length, shielded/armored (EMC-compatible installation)
Max. motor cable length, non-shielded/unarmored
Max. cross-section to motor, line power*
Cross-section DC terminals for filter feedback on enclosure frame H1-H3, I2, I3, I4
Cross-section DC terminals for filter feedback on enclosure frame H4-H5
Maximum cross-section to control terminals, rigid wire
Maximum cross-section to control terminals, flexible cable
Minimum cross-section to control terminals
*See chapter 1.7.2 Line Power Supply 3x380–480 V AC for more information
Digital inputs
Programmable digital inputs
Terminal number
Logic
Voltage level
Voltage level, logic '0' PNP
Voltage level, logic '1' PNP
Voltage level, logic '0' NPN
Voltage level, logic '1' NPN
Maximum voltage on input
Input resistance, R
Digital input 29 as thermistor input
Digital input 29 as Pulse input
Analog inputs
Number of analog inputs
Terminal number
Terminal 53 mode
Terminal 54 mode
Voltage level
Input resistance, R
Max. voltage
Current level
Input resistance, R
Max. current
Analog output
Number of programmable analog outputs
Terminal number
Current range at analog output
Max. load to common at analog output
Max. voltage at analog output
Accuracy on analog output
Resolution on analog output
1) Terminal 42 and 45 can also be programmed as digital outputs.
44
Quick Guide
i
i
i
Danfoss A/S © Rev. 2014-01-22 All rights reserved.
See chapter 1.7.4 EMC Test Results
Fault: >2.9 kΩ and no fault: <800 Ω
Max. frequency 32 kHz Push-Pull-Driven & 5 kHz (O.C.)
Parameter 6-19: 1=voltage, 0=current
Parameter 6-29: 1=voltage, 0=current
Max. error: 0.4% of full scale
50 m
4 mm 2 /11 AWG
2
16 mm /6 AWG
2
2.5 mm /14 AWG)
2
2.5 mm /14 AWG)
0.05 mm 2 /30 AWG
4
18, 19, 27, 29
PNP or NPN
0–24 V DC
<5 V DC
>10 V DC
>19 V DC
<14 V DC
28 V DC
Approx. 4 kΩ
2
53, 54
0–10 V
Approx. 10 kΩ
20 V
0/4 to 20 mA (scalable)
<500 Ω
29 mA
2
1)
42, 45
0/4–20 mA
500 Ω
17 V
10 bit
MG18A522