Danfoss VLT HVAC Basic Drive FC 101 Quick Manual page 33

Quick Guide
Parameter
3-42 Ramp 1 Ramp Down Time 0.05–3600.0 s
4-12 Motor Speed Low Limit
[Hz]
4-14 Motor Speed High Limit
[Hz]
4-19 Max Output Frequency
Table 1.23 Motor Set-up
Changes Made
Changes Made lists all parameters changed from default settings.
•
The list shows only parameters which have been changed in the current edit set-up.
•
Parameters which have been reset to default values are not listed.
•
The message 'Empty' indicates that no parameters have been changed.
To change parameter settings
1. Press [Menu] to enter the Quick Menu until indicator in display is placed above Quick Menu.
▲ ▼
2.
Press [ ] [ ] to select wizard, closed-loop set-up, motor set-up or changes made, then press [OK].
▲ ▼
3.
Press [ ] [ ] to browse through the parameters in the Quick Menu.
4. Press [OK] to select a parameter.
▲ ▼
5.
Press [ ] [ ] to change the value of a parameter setting.
6. Press [OK] to accept the change.
7. Press either [Back] twice to enter "Status", or press [Menu] once to enter "Main Menu".
The Main Menu accesses all parameters.
1. Press [Menu] until indicator in display is placed above "Main Menu".
▲ ▼
2.
Press [ ] [ ] to browse through the parameter groups.
3. Press [Ok] to select a parameter group.
▲ ▼
4.
Press [ ] [ ] to browse through the parameters in the specific group.
5. Press [Ok] to select the parameter.
▲ ▼
6.
Press [ ] [ ] to set/change the parameter value.
MG18A522
Quick Guide
Range
0.0–400 Hz
0.0–400 Hz
0-400
Danfoss A/S © Rev. 2014-01-22 All rights reserved.
Default Function
Size related Ramp-down time from rated
1-23 Motor Frequency to 0
0.0 Hz Enter the minimum limit for low
speed
65 Enter the maximum limit for high
speed
Size related Enter the maximum output frequency
value
1 1
31