Data Hub License - Keithley S535 Administrative Manual

Section 4: Maintenance

Data hub license

The data hub license allows the Keithley Test Environment (KTE) software to communicate with a
prober. This license is installed on all systems when they are shipped.
If you upgrade or reinstall the KTE software, you may need to reinstall the data hub license.
To upgrade systems with KTE version 5.8.0 and later:
1. Open a new Linux
2. Type licCheck and press Enter to check if the datahub license is installed correctly.
3. If it is not installed correctly, you will need to edit the file at $KIHOME/.ki_setup, where
$KIHOME/.ki_setup is usually opt/kiS530/.ki_setup.
4. Go to line 33 in the file and change it to setenv COMPUTERNAME q1234 (where 1234 is your
QMO number).
5. Reboot the computer to reinitialize the datahub.
4-12
®
terminal session.
Figure 49: Check datahub license installation
S535 Wafer Acceptance Test System Administrative Guide
S535-924-01 Rev. B / January 2019