Configuration Menu - Lexmark B2650 Service Manual

3
Find, and then manually toggle the sensor.
Notes:
•
The sensor status on the screen toggles between 1 and 0 when the sensor is properly working.
•
If a sensor test fails, the test failure may not indicate a failed sensor. Further troubleshooting may be
required. Check the boards and cables for possible issues.
List of sensor tests
Test
Pick roller index (tray [x])
Media low (tray [x])
Pass-through (tray [x])
Media size (tray [x]) switch [x]
Motor tests
For non-touch-screen printer models, press
1
Enter the Diagnostics menu, and then navigate to:
Additional input tray diagnostics > Motor tests
2
Select a motor, and then press
Notes:
•
If the motor is activated, then it is properly working.
•
Some motors require automatic deactivation in order to avoid secondary issues such as possible
damage and contamination.
•
Some tests require a special action to activate a motor such as removing a major component.
•
If the motor fails, the test failure may not indicate a failed motor. Further troubleshooting may be
required. Check the boards and cables for possible issues.
Configuration Menu
Menu item
USB Configuration
USB PnP
1*
2
USB Configuration
USB Scan to Local
On*
Off
Note: An asterisk (*) next to a value indicates the factory default setting.
Procedure to perform before the test
Remove tray [x].
to navigate through the settings.
or touch Start.
Description
Change the USB driver mode of the printer to improve its
compatibility with a personal computer.
Set whether the USB device driver enumerates as a USB
Simple device (single interface) or as a USB Composite device
(multiple interfaces).
Service menus
147
4600-830, -835, -895