Lexmark 910 Series Quick Manual

Please save this sheet for future reference.
1

Unpack your printer

Note: Contents may vary.
2

Prepare the printer

Connect the power
Make sure the Power
2
1
cord.
light is on.
2
1
4

Install the print cartridges

Open the Remove the photo
1 2
access cover. cartridge from the
print cartridge storage
unit.
Reminder: Save the print
cartridge storage unit to
protect new or partially used
cartridges.
910 Series
~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~
~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~
~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~
~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~
Press + to scroll to
3
your language, and
then press .
2
1
Remove the sticker and tape from
3
the bottom of the print cartridges.
1 1
2 2
Warning: Do not touch the copper
contact area on the back or the metal
print cartridge nozzles on the bottom.
www.lexmark.com
Safety information
• Use only the power supply provided with this product or the manufacturer's authorized
replacement power supply.
• Connect the power supply cord to an electrical outlet that is near the product and easily
accessible.
• Refer service or repairs, other than those described in the user documentation, to a professional
service person.
CAUTION: Do not set up this product or make any electrical or cabling connections, such as the
power supply or telephone, during a lightning storm.
3

Load paper

Lift the paper
Load the paper.
1
2
support and extend
the paper exit tray.
Open the cartridge lids, insert the cartridges,
4
and snap the cartridge lids closed.
1 2 3
*11X1111*
? ?
? ?
? ?
~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~
~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~
~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~
http://support.lexmark.com/
Lower the paper feed guard,
3
squeeze the paper guide, and slide
it to the left edge of the paper.
3
2
1
Close the
6
5
Press to print
access cover.
an alignment page.
You may discard the
alignment page after it
prints.
If you are using your
printer with a
computer, continue
with "Install the
software"...