Nortel Remote Office 9150 Installation And Administration Manual page 244

Configuring the Remote Office 9150 unit
Notes: You can configure a maximum of sixteen (16) Bridge Ports. You must
configure at least one SCR key on the set for the Bridge Port feature to work.
You must configure Bridge Port parameters on both the RLC and Remote Office
9150 unit. For information regarding Bridge Port configuration on the RLC,
refer to the Reach Line Card Installation and Administration Guide
(NTP 555-8421-210).
Note: Local Only sets do not support conference calls to a local Remote Office
9150 unit or to a host PBX. Local Only sets can dial host PBX DNs using an
enabled Bridge Port.
Configuring Bridge Ports reduces the total number of ports available from the
RLC.
Call processing capabilities and station settings
Each station can be defined as a telephone that can process
n
local calls only
n
remote calls only
n
local and remote calls
Stations defined with local call capability are further defined with telephone
features and local call appearance keys. Stations that are defined with remote
call capability do not need to be further configured because they inherit their
features and call appearance keys from their associated port configurations on
the host PBX.
Local call capability
Stations defined as local can make and receive calls through the local PSTN or
to other stations at the Remote Office 9150 site. Calls through the host PBX are
not allowed.
Local stations are not associated with RLC ports.
Remote call capability
Stations defined as remote are associated with RLC ports, and can make and
receive calls through the host PBX only. Calls through the local PSTN are not
allowed.
220
Standard 2.0
Remote Office 9150